PIC16C717T-E/SS【PDF 10/220 页】IC MCU OTP 2KX14 A/D PWM 20SSOP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3890

6页 7页 8页 9页 [10页]11页 12页 13页 14页

2002 Microchip Technology Inc.

DS41120B-page 105

PIC16C717/770/771

11.0

ANALOG-TO-DIGITAL

CONVERTER (A/D) MODULE

The analog-to-digital (A/D) converter module has six

inputs for the PIC16C717/770/771.

The PIC16C717 analog-to-digital converter (A/D)

allows conversion of an analog input signal to a corre-

sponding 10-bit digital value, while the A/D converter

in the PIC16C770/771 allows conversion to a corre-

sponding 12-bit digital value. The A/D module has up

to 6 analog inputs, which are multiplexed into one

sample and hold. The output of the sample and hold is

the input into the converter, which generates the result

via successive approximation. The analog reference

voltages are software selectable to either the device’s

analog positive and negative supply voltages (AVDD/

AVSS), the voltage level on the VREF+ and VREF- pins,

or internal voltage references if enabled (VRH, VRL).

The A/D converter can be triggered by setting the GO/

DONE bit, or by the special event Compare mode of

the ECCP module. When conversion is complete, the

GO/DONE bit returns to ’0’, the ADIF bit in the PIR1

enabled.

The A/D converter has a unique feature of being able

to operate while the device is in SLEEP mode. To oper-

ate in SLEEP, the A/D conversion clock must be

derived from the A/D’s internal RC oscillator.

The A/D module has four registers. These registers

are:

A/D Result Register Low ADRESL

A/D Result Register High ADRESH

A/D Control Register 0 (ADCON0)

A/D Control Register 1 (ADCON1)

A device RESET forces all registers to their RESET

state. This forces the A/D module to be turned off and

any conversion is aborted.

11.1

Control Registers

The ADCON0 register, shown in Register 11-1, con-

trols the operation of the A/D module. The ADCON1

tions of the port pins, the voltage reference configura-

tion and the result format. The ANSEL register, shown

in Register 3-1, selects between the Analog or Digital

Port Pin modes. The port pins can be configured as

analog inputs or as digital I/O.

The combination of the ADRESH and ADRESL regis-

ters contain the result of the A/D conversion. The reg-

ister pair is referred to as the ADRES register. When

the A/D conversion is complete, the result is loaded

into ADRES, the GO/DONE bit (ADCON0<2>) is

cleared, and the A/D interrupt flag ADIF is set. The

block diagram of the A/D module is shown in

Figure 11-3.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式